Comparative Study of Bit Error Rate in LDPC Based OFDM System over AWGN Channels
Abstract
Modern communication systems are increasingly adopting new Morden technologies like OFDM and LDPC for achieving high performance, low Bit Error Rate (BER) and high capacity. The OFDM communication is very much inspired from the channel frequencies over the network. In such a network some kind of orthogonal distortion occurs over the channel called Inter Carrier Interference.
Keywords
Download Options
Introduction
In this chapter, we firstly review some important technologies that contribute to the modern digital communication system. These techniques, including the Orthogonal Frequency Division Multiplexing (OFDM) modulation and Low Density Parity Check (LDPC) code, will be the main topic of the dissertation. Following the problem statement, dissertation objective is introduced. Finally, the outline of the dissertation will be given.
OFDM represents a different system design approach. It can be thought of as a combination of modulation and multiple access schemes that segment a communication channel in such a way that many users can share it. Whereas TDMA segments are according to time and CDMA segments are according to spreading codes, OFDM segments are according to frequency. It is a technique that divides the spectrum into a number of equally spaced tones and carries a portion of a user's information on each tone. A tone can be thought of as a frequency, much in the same way that each key on a piano represents a unique frequency. OFDM can be viewed as a form of frequency division multiplexing (FDM), however, OFDM has an important special property that each tone is orthogonal with every other tone. FDM typically requires there to be frequency guard bands between the frequencies so that they do not interfere with each other. OFDM allows the spectrum of each tone to overlap, and because they are orthogonal, they do not interfere with each other. By allowing the tones to overlap, the overall amount of spectrum required is reduced.
Conclusion
4.1 OFDM Spectrum
Orthogonal Frequency Division Multiplexing method has been used for spectrum generation. The main reason of using OFDM spectrum is that is distributes the data over large number of carriers that are spaced apart at different precise frequencies.
4.2 AWGN Channel
ADDITIVE WHITE GAUSSIAN noise (AWGN) channel is a universal channel model for analyzing modulation schemes. In this model, the channel does nothing but add a white Gaussian noise to the signal passing through it. This implies that the channel’s amplitude frequency response is flat(thus with unlimited or infinite bandwidth) and phase frequency response is linear for all frequencies so that modulated signal pass through it without any amplitude loss and phase distortion of frequency components.
4.3 BER Vs SNR of the LDPC Based OFDM system in AWGN channel Using QAM
Using MATLAB Figure2 shows the BER Vs SNR of the LDPC Based OFDM system in AWGN channel using QAM modulation scheme. This figure shows the relationship between BER and SNR. The values of SNR are from – 30 db to 0 db and the scale of SNR is linear. The values of BER are from 0.1 to 0.5 and scale of BER is log